Vulcan Series 30 Car Carrier
© 2010 East Penn Carrier and Wrecker Sales, Inc
1100 Win Drive
Bethlehem, PA 18017
Eastern Division: 610-694-9234
Toll Free: 800-432-5446
Fax: 610-691-0239
Western Division: 724-342-1800
Fax:724-983-1920
Click here to view East Penn's Privacy Policy
Prices and information subject to change without notice
Not responsible for typographical errors
Series 30
  • Outside stack pockets with rub rails and pipe
    spool
  • PTO
  • Apitong wood floor
  • Additional key slots
  • Stationary cab protector (requires 10" additional CA)
  • Stainless steel chain tray (for stationary cab
    protector)
  • Switch panel
  • Strap & bridle kits
  • Optional color on top of deck and side rails
  • Removable side rails
  • Tool compartments
  • Smooth floor in lieu of diamond plate
  • Dual key slots down center or deck edge
  • Bolt on D-rings
  • Drop wheel wells on deck
  • Work area & emergency lighting
  • Tie-down chains
  • Winch cage
  • Wired or wireless winch remote
OPTIONAL FEATURES
BED SPECIFICATIONS
STANDARD FEATURES FOR ALL VULCAN CARRIERS

  • Consolidated tilt & full length mounting
    frame
  • Black acrylic urethane paint
  • Two front safety chains
  • Hydraulic winch & cable
  • Winch clutch release
  • Bed anti-tilt feature
  • Dual lift cylinders
  • One extension cylinder
  • 20,000lb planetary winch with air free
    spool
  • 6" on center crossmember spacing
    hydraulic dock stabilizer

  • Full length nylatron slide pads
  • Driver's & passenger side chain trays
  • Positive lock down system
  • Dual illuminated controls
  • Back up alarm
  • Hydraulic pump
  • Mud flaps
  • Federal signal 108 lighting
  • 12 Tie down points
  • Steel tube cab protector
  • Load rating - 30,000lbs
  • Platform length - 24', 26', 28', 30'
  • Platform thickness - 3/16" floorplate
  • Platform width (outside) - 102"
  • Platform width (inside) - 98"
  • Platform mainbeam - 8" I-beam
  • Platform crossmembers - 2" x 4" cor-ten
    steel
  • Crossmember spacing - 6" on center
  • Platform sides - 7" x 4" angle with 24" C/C
  • Subframe - 7" x 4" x 3/8" tube
  • Rear Pivot - 1 Piece 2" diameter
  • Winch (1st layer) - 20,000lb Planetary gear
  • Cable - 9/16" 100'
  • Power lift cylinders - 5" x 32" stroke
  • Extension cylinder - 5 " 120" stroke
  • Wheel lift rating - N/A
  • Optional tow bar rating - N/A
TRUCK SPECIFICATIONS
  • Minimum GVWR - 50,000lbs
  • Minimum Cab to Axle (Clear) - 24' / 142", 26'/166", 28'/190", 30/214"
  • Minimum frame RBM (each) rail tandem axle - 2.5 million inch pounds
  • Minimum frame length behind center of rear axle - 60'
**Reinforcement extended to the rear of the frame**
* A heavy durty build up kit is available on a single axle and is required for a 20 series mounted on a
tandem or with an additional axle*